9-4X Brake Pedal Does Not Release After Apply - Brake Lights Stay On
[FONT=Times New Roman]Service and Warranty Reference Library
[/FONT]
Title: 9-4X Brake Pedal Does Not Release After Apply - Brakes Remain Applied or Brake Lights Stick On
Date: |
02/12/2014 |
To: |
2011 Saab 9-4X (GMT168) |
From: |
SPNA Technical Assistance |
______________________________________________
[FONT=Trebuchet MS]Title: 9-4X Brake Pedal Does Not Release After Apply - Brakes Remain Applied or Brake Lights Stick On[/FONT]
[FONT=Trebuchet MS]MODELS: 2011 Saab 9-4X (GMT168) [/FONT]
[FONT=Trebuchet MS]CONDITION/CONCERN[/FONT][FONT=Trebuchet MS]: [/FONT]
[FONT=Trebuchet MS][/FONT][FONT=Trebuchet MS]A customer or technician may comment the brake pedal may not raise or seem stuck down after a normal braking event. The condition will typically occur in high temperature/high humidity conditions and may not be repeatable. The brake lights may remain on and the brakes may drag after the pedal is released. A pop, click or snap noise may be heard when pedal is applied or released, but is not always noticeable or present. [/FONT]
[FONT=Trebuchet MS]This could drain the battery if the pedal is left depressed for extended periods.[/FONT]
[FONT=Trebuchet MS]If the concern is intermittent allow the vehicle to idle for 30 minutes with the heat on high, in floor mode to try and induce the concern.[/FONT]
[FONT=Trebuchet MS][/FONT]
[FONT=Trebuchet MS]RECOMMENDATIONS/INSTRUCTIONS:[/FONT][FONT=Arial][/FONT]
[FONT=Trebuchet MS][/FONT][FONT=Trebuchet MS]There is a bind in the brake pedal pivot bushing, replace the brake pedal/w bushings and the 2 retaining clips.[/FONT]