Control / Oil level adjustment
The following methods comprise two operating procedures:
1. Oil level control and refueling prior to engine shut down.
2. Oil level control with the engine running.
Quote:
Comment
Both operational steps should be performed in the order listed below. The oil level should be checked only the specified oil temperatures after intervening in the gearbox or if you suspect you may have an oil leak. Use oil according to the volume and quality of oil.
Control with engine off
1. Put the car on a lift as horizontal as possible. Apply the parking brake and put the change in position P. If using an elevator track, the wheels should be blocked. Attach the suction system exhaust.
2. Raise the vehicle. Remove the engine undercover and place a collecting container under the gearbox.
Remove the pipe plug oil level.
http://img9.imageshack.us/img9/3729/nivel.jpg
3. If oil goes through the hole of the tube level, refuel gearbox oil until it begins to pour. Disregard the oil contained in the tube level. Mount the cap.
Tightening torque, level cap 8 Nm (7 lbf ft)
4. Enter 1 liter of oil around the fill hole.
Control of oil at a temperature from 30ºC to 45º C
1. Lower the car.
2.
Connect the Tech2. Operate the engine until the temperature reaches 30 ° to 45 ° C according to the menu "Check Values" TCM. Move the gear selector position P to D and then, from D to P. Let the march more than 2 seconds in each position (N and R) while stepping on the brake pedal. Repeat twice.
3. Leave the engine running and lift the car. Place a collection container under the gearbox and remove the pipe plug oil level.
4. It will get a correct oil level when it ceases to be discharged by the oil level hole. Disregard the oil contained in the tube level.
5. If the oil level is below or level flush pipe, not pour any oil content than the level in the tube. In that case you must fill oil. Mount the cap.
Tightening torque, level cap 8 Nm (7 lbf ft)
Filling
1. Lower the vehicle and turn off the engine.
Remove the filler cap and top up approx. 0.5 liters of gearbox oil. See Weight, torque, volume and quality oil.
http://saabworld.net/
2. Start the engine, put the gear selector position P to D and then D to P. Allowed to stand up more than 2 seconds in each gear position coupled (N and R) while the pedal is the brake. Repeat this procedure twice.
3. Raise the car and rechecking the oil level. Add if necessary. Fit the drain plug when leaving the oil.
Tightening torque, level cap 8 Nm (7 lbf ft)
4. Mount the engine undercover.
5. Lower the car, stop the engine and mount the fill hole plug.
Tightening torque, oil filler 30 Nm (22 lbf ft)
6.
Tech2 Disconnect the vacuum system and the exhaust
Check and adjust level with the oil temperature between 70 and 80 º C.
1. Carry out checks and filling as above, and then add another approximately 0.4 liters.
