Search:
Type: Posts; User: Yamarocket630
Search: Search took 0.00 seconds.
-
24 March 2024
- Replies
- 1
- Views
- 1,105
Many of eeuro's parts are sold as "OEM Quality"...
Many of eeuro's parts are sold as "OEM Quality" because the manufacturer also makes and sells parts for OEMs. It's more of an indication of supposed part quality. However most manufacturers can and...
-
30 December 2023
- Replies
- 0
- Views
- 1,055
2006+ Fuel pump replacement - tank removal method for US/CA spec cars
-Yes, you can cut up your floor to enlarge the access hole. Please don't do this. Its a hack job. Removing the tank isn't that hard. You got this.
You need simple hand tools including a 10mm... -
27 September 2022
Thread: Front crankshaft sleeve -seal leak
by Yamarocket630- Replies
- 9
- Views
- 3,454
Did you do the glove test to verify the oil trap...
Did you do the glove test to verify the oil trap isnt clogged? For the $30 or so that it costs i would just replace it while youre in there.
-
22 September 2022
Thread: Front crankshaft sleeve -seal leak
by Yamarocket630- Replies
- 9
- Views
- 3,454
If you think you might have to replace the...
If you think you might have to replace the pressure switch you might as well do the oil trap at the same time.
Do yourself a favor and take the front exhaust section off. It comes off a lot easier... -
22 September 2022
Thread: Front crankshaft sleeve -seal leak
by Yamarocket630- Replies
- 9
- Views
- 3,454
Well i had a whole nice long post and lost it. ...
Well i had a whole nice long post and lost it.
Cliff's notes version:
Use one hand to squeeze the clip and the other hand to pry the line loose with a small prybar. There is just enough room... -
13 September 2022
Thread: Front crankshaft sleeve -seal leak
by Yamarocket630- Replies
- 9
- Views
- 3,454
The quick way to test your oil trap for being...
The quick way to test your oil trap for being clogged in the glove test. Take the dipstick out, put a surgical type glove over the dipstick tube and if it isnt tight, put a rubber band around it....
-
09 September 2022
Thread: Front crankshaft sleeve -seal leak
by Yamarocket630- Replies
- 9
- Views
- 3,454
The sleeve is only necessary if the old seal has...
The sleeve is only necessary if the old seal has worn a groove into the pully.
Check that the PCV system is working correctly. When my oil trap was clogged, crankcase pressure pushed my crank seal... -
09 September 2022
Thread: 2007 95 starting issues
by Yamarocket630- Replies
- 3
- Views
- 1,955
Your battery tested as "good, recharge" meaning...
Your battery tested as "good, recharge" meaning its not fully charged. You need to check for an excessive current draw with the ignition off.
-
09 August 2022
- Replies
- 1
- Views
- 1,226
That is a classic sign of low refrigerant.
That is a classic sign of low refrigerant.
-
09 August 2022
Thread: I found this tube near the battery
by Yamarocket630- Replies
- 4
- Views
- 1,596
That is part of the brake vacuum pipe. I'm...
That is part of the brake vacuum pipe. I'm assuming it was replaced recently. If not it needs to be.
-
05 January 2022
Thread: New throttle body problem
by Yamarocket630- Replies
- 1
- Views
- 1,311
If it isnt setting a DTC for the throttle body,...
If it isnt setting a DTC for the throttle body, it's very unlikely the throttle body is at fault. Check for vacuum leaks.
-
20 May 2021
- Replies
- 477
- Views
- 833,343
Its an interesting way you connected the steering...
Its an interesting way you connected the steering wheel controls and the speaker level outputs to the amp.
I went through 5 different head units trying to get one with good sound quality. All of... -
11 February 2021
- Replies
- 477
- Views
- 833,343
I just (almost) finished installing an Android...
I just (almost) finished installing an Android head unit. I still need to install some GLIs to eliminate the pop noise most other people have had, but otherwise it works good and I'm happy with it....
-
13 December 2020
- Replies
- 1
- Views
- 2,872
The green and red, yes those are the input and...
The green and red, yes those are the input and output speed sensors. The one closest to the front of the car is the input.
The first circled harness passes through the tranmission case and is the... -
13 December 2020
- Replies
- 38
- Views
- 40,955
PSA: Drawtite 36286
- If you have one of these hitches on your car and live in the rust belt, you should check it closely for rust. They tend the rust from the inside out and so may look just fine on a quick...
-
30 December 2016
- Replies
- 36
- Views
- 48,936
I did the exact same "fix" about a year and half...
I did the exact same "fix" about a year and half ago with no more occurrences of the brake lights staying on or Service ESP messages. I used a parking brake cable return spring I had laying around...
-
03 October 2016
- Replies
- 2
- Views
- 2,704
Are you SURE is isn't the oil pressure switch...
Are you SURE is isn't the oil pressure switch leaking?
-
03 October 2016
- Replies
- 3
- Views
- 2,706
It is the canister close valve. It is part of...
It is the canister close valve. It is part of the evaporative emissions control system. It's not likely to be your problem causing P1181. Make sure you do not have any vacuum leaks. Especially...
-
09 August 2016
- Replies
- 35
- Views
- 33,056
Excellent! If I'm ever unlucky to have this...
Excellent! If I'm ever unlucky to have this happen to my 2011 you're just down the road from me. The 3rd brake light failed last summer, fortunately I found a new one for $60.
-
10 July 2016
- Replies
- 17
- Views
- 29,258
A 9-3SS wont start with a weak battery, it won't...
A 9-3SS wont start with a weak battery, it won't even crank over. They are very sensitive to battery voltage, more than most cars. Also, a 12v lead acid battery at 10.9v is about 90% discharged.
-
26 October 2015
Thread: Loss of coolant - water pump?
by Yamarocket630- Replies
- 60
- Views
- 45,764
I've been using vasoline for 20 years. Never had...
I've been using vasoline for 20 years. Never had a problem.
-
26 October 2015
Thread: Loss of coolant - water pump?
by Yamarocket630- Replies
- 60
- Views
- 45,764
If it was a steady dripping with the engine not...
If it was a steady dripping with the engine not even running in the cooling system not under pressure it's probably something simple like a clamp that is not in place or O-ring that split or rolled...
-
08 August 2015
Thread: Loss of coolant - water pump?
by Yamarocket630- Replies
- 60
- Views
- 45,764
Check the air bleed hose on the passenger side of...
Check the air bleed hose on the passenger side of the radiator at the top if you reuse that hose clamp is probably not holding it securely anymore
-
28 July 2015
Thread: Loss of coolant - water pump?
by Yamarocket630- Replies
- 60
- Views
- 45,764
Pretty much impossible to get One with everything...
Pretty much impossible to get One with everything in place. I tried.
-
28 July 2015
Thread: Loss of coolant - water pump?
by Yamarocket630- Replies
- 60
- Views
- 45,764
Line that up with the "open" part of the clamp...
Line that up with the "open" part of the clamp where the screw to tighten it is. I believe there is another notch in the clamp that will line up with the protrusion at the top. Hold the pipe in...
Results 1 to 25 of 69