Welcome to the world of Saab ! Register

Search:

Type: Posts; User: Finding41

Page 1 of 20 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    107
    Views
    332,431

    Hi. I took all the motor mounts except the top...

    Hi. I took all the motor mounts except the top transmission one off and jacked the engine up. Then I used a swivel extension to get in to the one and a 1/4 drive short socket and ratchet to get the...
  2. I installed rubber spacers then metal ones. The...

    I installed rubber spacers then metal ones. The rubber ones fell out... So did one of the metal ones.
    On the third install... I drilled holes through the center of the metal spacers and used a Zip...
  3. Replies
    37
    Views
    102,053

    On the inside of the fuse lid is a diagram. Or...

    On the inside of the fuse lid is a diagram. Or Google a diagram.
  4. Replies
    37
    Views
    102,053

    Under the hood in the fuse box Ther are a bunch...

    Under the hood in the fuse box Ther are a bunch of relays. Start swappingg them out.
    Check the causes and the fuse box lid to see what delay is for the high lights.
  5. Replies
    14
    Views
    85,425

    I think your PVC system is plugged. Or at least...

    I think your PVC system is plugged. Or at least part of it.
    I'd start cleaning check valves and hoses. Its kind of a pain in the a... To take the PVC tank off the back of the block. (tip) loosen the...
  6. Replies
    284
    Views
    156,954

    Congratulations Frank! Hope all is well over...

    Congratulations Frank!
    Hope all is well over here. I've moved on to another Swedish Car. (I'm still looking for a 2011 9-5 wagon.)
    I have a XC90 (Prancing Moose Edition!) now and am shopping for...
  7. Replies
    14
    Views
    85,425

    No. The 05 has a different pvc system. It has a...

    No. The 05 has a different pvc system. It has a hole in the back of the block that goes directly into the pvc box behind the engine.
  8. Replies
    85
    Views
    63,452

    You can't mess up the timing just by replacing...

    You can't mess up the timing just by replacing the serp belt.
    You need a code reader. Don't get a Bluetooth one. Get one that plugs in via wire. I've never got a bluetooth one to work with my...
  9. Replies
    85
    Views
    63,452

    I'd try un-hooking hte battery for about 10 min....

    I'd try un-hooking hte battery for about 10 min. That should reset things. (Kind of.)
    There may be an ignition problem (SID? ) The coil packs go on those and you have to replace the whole thing.
    I...
  10. Yep. Check the part that the cylinder fits into...

    Yep. Check the part that the cylinder fits into at the bottom. Also check the end of the cylinder. Is it worn?
    Good luck.
  11. Replies
    85
    Views
    63,452

    Its been a while. I think i used a swivel...

    Its been a while. I think i used a swivel extension or a extension with a cutaway swivwl end.
    I do remember that i has to use my grinder to thin the metal where the pan bolts on. I took 1.5mm off. ...
  12. No you cant make it non turbo. That would require...

    No you cant make it non turbo. That would require remapping.
    How are thebolts different with the other turbo?
  13. I'd just get what you took off. Then you know the...

    I'd just get what you took off. Then you know the lines fit.
  14. What model is it? I think the Aero will have the...

    What model is it? I think the Aero will have the big turbo.
    Isn't the small one a Garret and the Aero one Missubishi? What does yours say on it?
    I'm pretty sure you can't put a different one on.
  15. Replies
    14
    Views
    9,388

    Since your in there may as well change all the...

    Since your in there may as well change all the vacuum hoses and check the check valves to see if they operate properly. (Also see if they are facing the correct direction.)
    I'd check the...
  16. Here is a link to EBAY. I"m not sure if this is...

    Here is a link to EBAY. I"m not sure if this is the right turbo cartage for your car....
  17. Replies
    3
    Views
    1,733

    There should be a drain under the rad for the air...

    There should be a drain under the rad for the air cond. (Under the dash.) That is probably plugged. You may access it where the cabin air filter is...? I'm not positive on that. That's where it was...
  18. Replace. Typically the only cylinders that have...

    Replace.
    Typically the only cylinders that have replaceable seals are industrial.
    Good luck.
  19. Replies
    4
    Views
    1,504

    Lol. Not yet! We just stepped in the door form...

    Lol. Not yet!
    We just stepped in the door form a 2000km trip from PEI home. Only leaked 5L of oil on the way.
    I should have the turbo kit in someday this week. I'll rebuild it on the weekend. It's...
  20. Replies
    4
    Views
    1,504

    EDIT: I have rebuilt one of these once before.....

    EDIT:
    I have rebuilt one of these once before.. It's not that difficult. The worst part is getting the snap-ring back on.
    I modified a $2 pair of needle nose pliers to do it. Still have them.
    I...
  21. Replies
    4
    Views
    1,504

    I just ordered a rebuild kit from Ebay. Here is...

    I just ordered a rebuild kit from Ebay. Here is the link http://www.ebay.com/itm/262250184266
  22. Replies
    23
    Views
    166,855

    You have a hose that is disconnected or has a...

    You have a hose that is disconnected or has a hole in it. Just replace all the vacuum hoses. Any parts store will be able to help you figure out what size hose. Yes the code will disappear after a...
  23. Replies
    7
    Views
    10,196

    I still have a oil leak too. I swapped the oil...

    I still have a oil leak too. I swapped the oil pressure thing yesterday and washed the engine. It needs it again.... Hopefully I have it.
    Any luck trwilson70?
  24. Replies
    19
    Views
    17,730

    Try here:...

    Try here: http://saabworld.net/showthread.php?t=261
    And here: http://www.thesaabsite.com/95/FAQs.html#HEATING_&_COOLING_CATEGORY_-_Blend_Door_Right_Side_Gear_Issue
    The drivers side is a pain in...
  25. Replies
    2
    Views
    1,369

    I just fixed my drivers side window. The problem...

    I just fixed my drivers side window. The problem with the windows is the rubber molding falls out of the track at the back of the window. (I've seen this in 3 separate front doors.) When the rubber...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
All times are GMT. The time now is 10:42.
Powered by vBulletin® Version 4.2.5
Copyright © 2024 vBulletin Solutions Inc. All rights reserved.