Search:
Type: Posts; User: peva
Search: Search took 0.00 seconds.
-
09 December 2018
Thread: Replacing instrument panel lights
by peva- Replies
- 3
- Views
- 19,820
You will probably need to remove the dash to get...
You will probably need to remove the dash to get at these. It's a fiddly job. This link may give you some info; http://fixmysaab.com/900_repair/diydash/intro.asp?nsteps=6
-
23 March 2018
- Replies
- 6
- Views
- 22,052
Is it one of these? ...
Is it one of these? http://www.stevelewissaab.com/apps/webstore/products/show/5899196
-
22 March 2018
Thread: B202 Motor infomation
by peva- Replies
- 1
- Views
- 15,886
You'll find most of this info if you buy yourself...
You'll find most of this info if you buy yourself a Saab Bentley Manual. It's not cheap and by no means perfect. But it will have all the spec you need in it. Keep your eyes open , you do...
-
13 August 2017
Thread: Car stumbles at constant speed
by peva- Replies
- 4
- Views
- 8,590
I wouldn't guess at TPS. Sounds like ignition to...
I wouldn't guess at TPS. Sounds like ignition to to me. I would try new plugs for a start.
-
27 June 2017
- Replies
- 227
- Views
- 116,719
Get in touch with Emmett Jenner at...
Get in touch with Emmett Jenner at www.saabsforum.com. He'e done a few of these and I think there's also a thread in Saabs forum projects.
-
16 June 2017
Thread: Help identify rims
by peva- Replies
- 2
- Views
- 6,616
This link may assist. ...
This link may assist. http://peacetek.net/saab-wheels/
-
22 May 2017
- Replies
- 3
- Views
- 8,083
Your fuel pump may be failing. It does happen....
Your fuel pump may be failing. It does happen. Next time it doesn't start try thumping the bottom of the fuel tank with your fist. This is often sufficient to get a seized fuel pump stated again. You...
-
20 September 2016
Thread: injectors not getting power 85 900
by peva- Replies
- 1
- Views
- 7,725
Don't jump to conclusions if you know nothing...
Don't jump to conclusions if you know nothing about cars. The fuel system and injectors are probably fine. It could be that the ignition timing is incorrect if it's been messed with. Why can't you...
-
13 June 2016
- Replies
- 7
- Views
- 18,955
I'm no oil expert, but only the first you have...
I'm no oil expert, but only the first you have mentioned says Type F so why shouldn't you use it. The others may be fine, but I can't advise you more than this.
The Saab workshop manual calls for... -
13 June 2016
- Replies
- 7
- Views
- 18,955
The 900 auto gearbox is a Type-37 made by...
The 900 auto gearbox is a Type-37 made by Borg-Warner. It should have only Type F ATF. It's red, a little hard to find and not really compatible with any other fluid. If the fluid is clear, it's the...
-
12 June 2016
- Replies
- 7
- Views
- 18,955
It requires two different oils because the auto...
It requires two different oils because the auto gearbox and final drive are separated and require different oils. 19K seems a very low mileage. My advice; top up if required but don't change the oil....
-
08 June 2016
- Replies
- 1
- Views
- 3,017
Several possibilities; Alternator bearing...
Several possibilities;
Alternator bearing failure ( seems likely if bat light comes on occasionally). Check this by using a stethoscope on alt. body to check noise. Or use a long screwdriver... -
08 June 2016
Thread: rough starting
by peva- Replies
- 6
- Views
- 6,834
All engines run a vacuum at some time on light...
All engines run a vacuum at some time on light throttle, NA or turbo. If you are getting no vacuum on the hose connected to the intake plenum, either the engine is not running, the hose is blocked or...
-
29 May 2016
Thread: operating temp?
by peva- Replies
- 2
- Views
- 4,312
The factory gauge when working sits around middle...
The factory gauge when working sits around middle dial at operating temp. This equates to approximately 90°C, which is the same as the recommended engine thermostat. The top of the gauge is red...
-
14 May 2016
Thread: Rear brakes hard but don't work on saab 900
by peva- Replies
- 3
- Views
- 6,927
I would suggest you bleed the system more and if...
I would suggest you bleed the system more and if necessary, pressure bleed it.
Check out the Saab Manual for brakes.... -
02 May 2016
Thread: can't get rid of the vibration...
by peva- Replies
- 3
- Views
- 4,358
These parts are not available new. Your best bet...
These parts are not available new. Your best bet is to source a good used part from scrap yard or local Saab indie garage. There seem to me quite a few Saab Indies in the US. With good lubrication...
-
30 April 2016
Thread: can't get rid of the vibration...
by peva- Replies
- 3
- Views
- 4,358
Yes, it's play in the inner drivers. Either worn...
Yes, it's play in the inner drivers. Either worn driver cups or tripod bearings. Classic symptom on auto boxes. Doesn't happen on manuals. Definitely not engine mounts. Swapping sides on the driver...
-
18 February 2016
Thread: Bentley manual
by peva- Replies
- 1
- Views
- 3,557
The Bentley is OK, but it does have a few...
The Bentley is OK, but it does have a few mistakes.
-
24 October 2015
- Replies
- 4
- Views
- 4,810
3/4 of the way up the gauge is not overheating....
3/4 of the way up the gauge is not overheating. Overheating is when the gauge is in the top red section. The correct engine stat for the 900 is 90°C, which when the engine is fully warmed up should...
-
14 October 2015
Thread: Durability of Aluminum Cylinder Heads
by peva- Replies
- 3
- Views
- 3,951
Chance of it damaging the head is very low. If...
Chance of it damaging the head is very low. If anything is damaged it will be to the top of the timing chain cover which the bolts pass through. If it looks ok, it probably is.
-
30 July 2015
Thread: i need to get this saab running..
by peva- Replies
- 5
- Views
- 4,564
Does it start with 'Easystart' (ether) sprayed...
Does it start with 'Easystart' (ether) sprayed into the intake? Do this through an intake rubber bush. If it runs it's probably a fuel issue. If it doesn't run it's probably spark and I would first...
-
20 July 2015
Thread: Overheating problem
by peva- Replies
- 12
- Views
- 8,910
You may just have a water leak. The fumes can get...
You may just have a water leak. The fumes can get through the vent system and smell strange. Check that the coolant level is not going down.
-
20 July 2015
Thread: need help 1986 900 turbo no start
by peva- Replies
- 14
- Views
- 7,384
This is a good headlining guide....
This is a good headlining guide. https://web.archive.org/web/20120916081823/http://www.paradisesaabs.com/diy-headling-retrim-guide.html
-
20 July 2015
Thread: 1988 90016T wont start...
by peva- Replies
- 2
- Views
- 4,144
Sounds like a sick motor. Response on the...
Sounds like a sick motor. Response on the throttle is very slow. Make sure timing is correct. You can check for fuel pressure by cracking open a banjo nut at the end of the fuel rail. Fuel should...
-
20 July 2015
Thread: Overheating problem
by peva- Replies
- 12
- Views
- 8,910
Provided the gauge is working and reading...
Provided the gauge is working and reading correctly it's not overheating. What does overheating smell like? It may be an oil leak onto the exhaust.
Results 1 to 25 of 252