Search:

Yes my local mechanic suggested the same thing. He did a compression test, cylinder 1 had no compression. The motor had no power and the idle got worse. For the amount of $$ and access for parts, I...

Thanks folks. I did replace the spark plugs with new ones around 30,000km ago with the NGK. I have the 2.3 aero B235R.

I tried again this morning and it sounds like one cylinder not firing, the...

Hi,

I think my timing chain is stuffed/ needs replacing? It has for while had small rattle sound but now it is loud and the engine idles rough and has no power . There are fault codes of P1300,...

Sorry I realised I didn't mention I found another door since I started this thread (two in total ), one mentioned and another for a wagon but with nothing inside. I wont grab the sedan one! thanks...

sorry for late reply, I'll grab the wagon door thanks

I have found the same door for same model etc (Saab 95 2000) but from a sedan with the window regulator and window in it (my car is a wagon).
Are the doors on SAAB 95 2000/2001 on the sedan the...

Thanks . This is what I was after.

Hi,

My passenger door window needs replacing (it is smashed). I have sourced a replacement window but cant seem to find instructions on how to remove the glass and replace it. I have the trim off...

No worries I will get the PVC update as mentioned I need to get it running properly. I have seen some good instructions on various forums so will do that.
I have had the car for 4 1/2 years and...

Thanks Swisssaabist much appreciated.

Do you think I should upgrade to the PCV # 6 kit? I have read some post where SAAB recalled the Upgrade kit?

15893Hi ,
I have 95 2001 aero and noticed the rubber tube coming out of the top of the engine is broken. I am not sure if my photo worked but the tube comes out top near the oil dipstick cap.When...

Thanks will try replacing O ring

Hi Digger, thanks for your reply makes sense.
It is a 2000/2001 and I doubt any of the lines have been changed
cheers Clayton

Hi,
Where I have circled the line pops out from the manifold, just below the bulb (sorry cant remember bulbs name). When it does pop out the engine runs rough, I push it back in and all is good....

I think it would be the sensor or loose connection to the sensor.

Interesting , my code is CL-DH-H-G-L-9. Built date is Feb 00
thanks

I believe I still have the originals on the front , SACHs 45 66 634 ( I have seen they were on the 95 aero's on the 2000 model). I checked the plate in the engine bay, it was built in 2000 as I...

Thanks for reply AeroV,
Interesting I managed to get hold of KYB Australia, they mentioned the KYB 335921 were for standard suspension, not the aero sports suspension that I have.
When I have...

Hi,
I am looking for new front struts for 95 2000 aero. It looks like I will have to from order overseas (hard to get in Aus.)

The current struts on the car are SACHS with the following numbers:...

Hi,
Just an update I found out from KYB Australia the struts I purchased were the standard suspension, not the sports. KYB Australia do not supply the Sports Suspension Struts for SAAB 95 Aero.

Hi
I am getting a P0705 code which I believe is a trans range sensor on the way out?
Is this easy to replace and are there any tutorials?
I also have vacuum leak every now and again. At the back...

hi,
I ordered some strut mounts ( I already had new struts). I was putting the new strut back into the car with the new strut mounts, I realised there was no thread in the strut mounts for the 3...

Hi,
Great instructions changed the thermostat recently and the temp gauge works properly, heating is so much better!
I do have a slight leak near the top of the radiator where the top hose...

Great thanks,

much appreciated

Clayton

Thanks , much appreciated
Clayton