Search:
Type: Posts; User: blobthebuilder
Search: Search took 0.00 seconds.
-
20 July 2019
Thread: Intermittent Vibration noise
by blobthebuilder- Replies
- 0
- Views
- 4,144
Intermittent Vibration noise
Ok car was making a ticking noise then threw a belt so had a 3mm shorter belt fitted and sounded like spanners in engine so mate said bottom crank pulley, that changed and terrible noises stopped but...
-
20 July 2019
- Replies
- 3
- Views
- 4,633
Mine was lower crank pulley but there is a...
Mine was lower crank pulley but there is a rubbing noise that comes and goes kinda sounds like plastic arch liner vibrating but none loose and if I turn steering it does it but if I increase revs...
-
12 July 2019
- Replies
- 3
- Views
- 4,633
Ok I gave car an oil and filter change and...
Ok I gave car an oil and filter change and thought that solved it but no, when cold next day the ticking was there and if left to idle it continues but if you take car for a mile or do drive it...
-
10 July 2019
- Replies
- 3
- Views
- 4,633
noticable ticking noise under bonnet
i have the 9-3 2.2 TiD and today it seems to sound more clattery with a distintive ticking noise on idle that goes away when revved or driving but it also has a low rythmic hum and it seems to be on...
-
22 June 2019
Thread: 2.2 tid exhaust
by blobthebuilder- Replies
- 0
- Views
- 5,016
2.2 tid exhaust
Is there any real options for exhausts for the 04 2.2 tid I like the bore exhaust look not the hidden look
-
19 June 2019
Thread: Odd turbo question
by blobthebuilder- Replies
- 0
- Views
- 3,509
Odd turbo question
When I start my car the wastegate rod is pulled right down I'm assuming closed does it do this if turbo has failed to stop it producing boost and destroying the engine
-
18 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
Little update, I've noticed the valve at end of...
Little update, I've noticed the valve at end of inlet manifold on right does nothing I even used a hand vacuum gauge and it doesn't move, can it be cause of problems
-
18 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
ok i tried a brand new bosch maf and it run like...
ok i tried a brand new bosch maf and it run like a bag of shite again but if disconnected runs fine just in limp mode, is the wastegate ment to pull in when car starts and it only plays up when...
-
17 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
Well I've tried another egr valve of a younger...
Well I've tried another egr valve of a younger lower mileage car and another solenoid which has pipes connected from air tank to swirl flap above egr and exactly the same but if I leave it plumbed...
-
16 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
Took valve off again took end off the motor...
Took valve off again took end off the motor seemed free moving and I cleaned the rod and throttle housing end agsin it seemed better but not great do I dont think it will get better with that 1,...
-
16 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
Ahh got you bud, well I'm sure it's the egr, I've...
Ahh got you bud, well I'm sure it's the egr, I've configured pipes at moment so it and wastegate aren't working so its drinkable but under heavy load like going up hill if its steep there is a lot of...
-
16 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
Were is the idle air valve on the 2.2 tid
Were is the idle air valve on the 2.2 tid
-
16 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
Thanks bud cleaning it made a marginal...
Thanks bud cleaning it made a marginal improvement but not much the lurching isnt as violent but its still not really drivable, I mean if you move mechanism with figures it moves and springs back...
-
16 June 2019
Thread: EGR fault
by blobthebuilder- Replies
- 9
- Views
- 5,356
EGR fault
Ok i'm wondering if the motor on an EGR can fail because i'm getting running problems, if i connect plumbing wrong the wastegate doesn't function nor does the EGR mechanism when revved and the car...
-
15 June 2019
Thread: lots of dry black smoke
by blobthebuilder- Replies
- 0
- Views
- 3,507
lots of dry black smoke
as the title says i couldnt find a vacuum hose diagram on internet that matched my car but by chance i when to breakers erlier and they had a car identical under bonnet to mine so i made a diagram of...
-
14 June 2019
Thread: lack of power
by blobthebuilder- Replies
- 0
- Views
- 3,008
lack of power
Im sorry if this is been covered before but ive looked through the vacuum diagrams and none match mine.. car is a 2004 saab 9-3 2.2 tid saloon arc
If i try and go uphill near top of rev band in...
Results 1 to 16 of 16