Search:
Type: Posts; User: East Tennessee USA
Search: Search took 0.00 seconds.
-
23 January 2018
- Replies
- 9
- Views
- 18,466
Problem solved! The issue was caused by either...
Problem solved! The issue was caused by either varnish buildup on the valve stems or deposits around the valve seats. I put a bottle of STP in the tank, and 4 oz. of Sea Foam in the oil. Then, ran...
-
20 January 2018
- Replies
- 9
- Views
- 18,466
Thanks for all the replies. I haven't gotten a...
Thanks for all the replies. I haven't gotten a chance to do much with it yet, but have been using the car every few days to help track the characteristics of it. Ambient temp has no effect. We've...
-
12 January 2018
- Replies
- 9
- Views
- 18,466
intermittent loss of compression all cylinders
I have a 1991 900s naturally aspirated with a 2.1. When you try to start it, it spins over so evenly that there can't possibly be any compression on any cylinder. It won't start, and the...
-
28 November 2017
Thread: ABS Delete
by East Tennessee USA- Replies
- 13
- Views
- 19,972
Thanks for the advice. I did get under the dash...
Thanks for the advice. I did get under the dash and look at the pushrod. It would be hard to judge which booster to get without first pulling my existing abs unit out of the car for comparison. ...
-
21 November 2017
Thread: ABS Delete
by East Tennessee USA- Replies
- 13
- Views
- 19,972
Thanks for the info. I was stuck thinking of...
Thanks for the info. I was stuck thinking of looking for a booster for an earlier model Saab, while I could have just went with something more common. Good call. First I'll find a booster that...
-
20 November 2017
Thread: ABS Delete
by East Tennessee USA- Replies
- 13
- Views
- 19,972
ABS Delete
I have a 1991 Saab 900 S that I am interested in deleting the ABS system. I would like to eliminate the pump/accumulator system and replace it with a basic vaccuum booster and master cylender. I've...
-
18 November 2017
Thread: Weak injector pulse
by East Tennessee USA- Replies
- 6
- Views
- 16,242
Well, I finally set down to solder the suspected...
Well, I finally set down to solder the suspected leg in the ecm circuit board, but wasn't able to do it because the space in there was just too small for me to do. I'll clarify what I was going to...
-
14 October 2017
Thread: Weak injector pulse
by East Tennessee USA- Replies
- 6
- Views
- 16,242
Hello! Sorry it's been so long, but I haven't...
Hello! Sorry it's been so long, but I haven't been able to work on the car much lately. Spraying the injectors by manually providing power and ground proved the injectors weren't at fault. I was...
-
11 September 2017
Thread: Weak injector pulse
by East Tennessee USA- Replies
- 6
- Views
- 16,242
Thanks for the info. My controller has a...
Thanks for the info. My controller has a Jetronic label on it. Bently publishers refers to my fuel injection system as Bosch LH2.4. I think the .6 DC volts is meant to be a ball park indicator for...
-
10 September 2017
Thread: Weak injector pulse
by East Tennessee USA- Replies
- 6
- Views
- 16,242
Weak injector pulse
Hello! I've lurked here for a while, but now I might be able to use some advice. I bought a 1991 900s about a year ago with a bad knock in the engine. The engine ran at that time, and I drove it...
Results 1 to 10 of 10