Welcome to the world of Saab ! Register

Search:

Type: Posts; User: SteveI

Search: Search took 0.00 seconds.

  1. Thread: ABS Questions

    by SteveI
    Replies
    21
    Views
    10,779

    Great write up... did you need to clear any codes...

    Great write up... did you need to clear any codes from the ABS control unit? I'm struggling with a permanent ABS light.
    Worked out how to pull the codes but not convinced I understand how to clear...
  2. You know that Johnny Cash song -about a car...

    You know that Johnny Cash song -about a car assembled from a miriade of other models............so ''one piece at a time'' it's been variously an 900i 8V, 900T 8V, 900T 8V with T16S...
  3. She's been running fine for 4 months and done...

    She's been running fine for 4 months and done 4000 miles without a hitch other than running a bit rich but I never had the CO2 adjusted and left the AMM at 380ohms ....2 days before the annual...
  4. Replies
    10
    Views
    6,558

    Just a quick update to close this one...

    Just a quick update to close this one down....checked the NTC and the relevent pins at the ECU end...all OK.

    Bit the bullet and splashed out - so sourced a replacement AMM this week and set it to...
  5. Replies
    10
    Views
    6,558

    In hindsight and the damage to the bank account...

    In hindsight and the damage to the bank account the sensible thing would have been to rebuild the 8V but a 16V came along complete with loom so was tempted into this folly!

    The change from 8v to...
  6. Replies
    10
    Views
    6,558

    Thanks Sam....I'll try again reving over 3K. ...

    Thanks Sam....I'll try again reving over 3K.

    I checked the NTC resistance and it looks to be OK..and varies in the right direction as the engine heats up.....maybe I'll measure resistance at the...
  7. Replies
    10
    Views
    6,558

    Ok..next question folks moving onto the AMM now...

    Ok..next question folks moving onto the AMM now (Bosch -005)

    Checking the burn off funtion for the AMM.....the books say 4 seconds after switch off (engine at normal temp and after 2500 rpm or...
  8. Replies
    10
    Views
    6,558

    Thanks for that Sam...your absolutely on the...

    Thanks for that Sam...your absolutely on the ball. I've not connected the RPM signal (blue wire that also feeds the tacometer) from the ignition amp yet or tried cranking the engine as it's been...
  9. Replies
    10
    Views
    6,558

    C900 LH2.2 ECU Pin Out Question.

    I'm upgrading from 8v to 16V and everything's gone fine until I tried to check out the fuel pump relay operation in advance of firing her up this weekend coming.

    I've decided to use the 2 relay's...
  10. Thanks Sam..been looking for a chart like that...

    Thanks Sam..been looking for a chart like that for days now. Thanks for the guidance on the ECU too..I'll post back once I have her running.

    SteveI
  11. C900 ECU Identification - or Scandinavian Roulette!

    I have an ECU with no external markings and need find it's part number.

    It's a Bosch 25 pin from I think a 88-89 16v turbo.

    Apart from a green circular sticker next to the label where the...
Results 1 to 11 of 11
All times are GMT. The time now is 20:23.
Powered by vBulletin® Version 4.2.5
Copyright © 2024 vBulletin Solutions Inc. All rights reserved.