Fan problem-not blowing any air in cabine

[Aca60]

I have 9.3 Convertible 98 model,until 2 h ago everything was working good,i wanted to take a ride on Sun with roof down so because was hot i wanted to turn on Air-con,on Control panel u can see how fan speed change but no air was coming inside.I can hear Air-con is working but no air in the carbine.If someone had a similar situation i will appreciate advise to solve a problem.Thanks.

[Shazam]

Press the "Auto" and "Off" buttons at the same time. The AC screen should flash real quick. This will trigger a little diagnostic test (takes maybe 30 seconds). While it is being run, you should see a number 0 on the screen. Then you should (hopefully) get a code to appear. Here are what the codes translate too.
01 – B1605 – ACC Module – Internal control module failure
02 - B1350 - Cabin Temp Sensor - Open circuit or short to battery or short to ground
03 - B1340 - Solar Sensor - Open circuit or short to battery or short to ground
04 - B1347 - Mixed-Air Temp Sensor - Open circuit or short to battery or short to ground
06 - B2492 - Mixed-Air Damper Stepping Motor - Open circuit or short to battery or short to ground
07 - B2496 - Mixed-Air Damper Stepping Motor - Jammed Damper
08 - B2495 - Mixed-Air Damper Stepping Motor - Loose Damper
12 - B2400 - Air Distribution Stepping Motor - Open circuit or short to ground
13 - B2406 - Air Distribution Stepping Motor - Jammed Damper
14 - B2405 - Air Distribution Stepping Motor - Loose Damper
20 - B2425 - Blower Motor Control Voltage - Open circuit or short to battery or short to ground
21 - B2410 - Recirculation Damper Motor - Open circuit or short to battery or short to ground
23 - B2945 - Sensor Ground - Open circuit or short to battery

[Burnsside42]

Does the blower work at all? If not - sounds like a blower speed controller went bad. Not a hard fix.

[Aca60]

all good,everything working,somehow,I just pres some buttons and AIR start working