Results 1 to 5 of 5
-
30 September 2014 #1
- Join Date
- 30 Sep 2014
- Location
- Dunbar
- Posts
- 13
- Saab(s)
- Saab 9-5 2.2 diesel Linear
oil filter removal saab 9-5 2.2 diesel
Hi, Wulf has kindly given me the info required to remove the air filter on my 9-5 linear. while I am under the car could someone help with the oil filter and drain plug location?
-
30 September 2014 #2
- Join Date
- 22 Apr 2013
- Location
- Tromsø, 69° 41' N
- Posts
- 464
- Saab(s)
- 2009 9-3 2.0T SC Aero XWD\eLSD. eSID2
Oil filter location / removal:
- Remove the upper engine cover.
- Unplug the EGR valve connector (#2 on the figure).
- Remove the oil filter housing cover, a 36mm socket is required.
Tightening torque: 26 Nm (19 lbf ft).
Oil drain plug is located on the bottom of the sump (pan), accessed by removing the lower engine cover. Tightening torque 18 Nm (13 lbf ft) - don't forget a new seal.
-
01 October 2014 #3
- Join Date
- 30 Sep 2014
- Location
- Dunbar
- Posts
- 13
- Saab(s)
- Saab 9-5 2.2 diesel Linear
Hi, thanks, can i take it that the location and instructions are the same for the 9-5 2.2 diesel engine?
-
01 October 2014 #4
- Join Date
- 22 Apr 2013
- Location
- Tromsø, 69° 41' N
- Posts
- 464
- Saab(s)
- 2009 9-3 2.0T SC Aero XWD\eLSD. eSID2
The information, from WIS, pertains to a MY2004 9-5 2.2 diesel.
-
02 October 2014 #5
- Join Date
- 30 Sep 2014
- Location
- Dunbar
- Posts
- 13
- Saab(s)
- Saab 9-5 2.2 diesel Linear
Hi guys, can anyone confirm the size of Torx bit required to remove sump plug? I think its a T45 can you confirm before I buy? Thanks