Results 1 to 3 of 3
-
14 May 2015 #1
- Join Date
- 14 May 2015
- Location
- Indiana
- Posts
- 2
- Saab(s)
- 2003 9-5 2.3T
Will crank but not fire
I put new plugs in my 2003 9-5 2.3T. I started right up drove it around the neighborhood everything was good. Next morning started it up no problems. Started in to work and about 5 minutes later it dies on me. Now it will crank but not fire. Could the DIC have gone bad or maybe the CPS? Any ideal where to look first?
-
14 May 2015 #2
Frank Administrator
- Join Date
- 30 Jul 2010
- Location
- USA - Netherlands
- Posts
- 7,901
- Saab(s)
- previous: 2006 9-3, 2001-06 9-5, 2011 9-4X
Did you use the recommended NGK plugs or different brand/type? Did you check the connector to the DIC to make sure it is still connected to the DIC correctly?
Hooking up an OBD2 reader may reveal some diagnostic codes.
-
14 May 2015 #3
- Join Date
- 14 May 2015
- Location
- Indiana
- Posts
- 2
- Saab(s)
- 2003 9-5 2.3T
yes I used NGK plugs and have double and triple checked the connector to the DIC. I have not pulled the DIC and done a firing test yet though.