Hi,

My 93 is experiencing a strange problem.

On startup it passes all checks.

Both left and right lamps work fine.

About 30 seconds later the right side flickers out and the error message is shown that the right low is out.

Both low and high beam are then out.

On the next startup it repeats.

Can't figure out why it does that, it is somewhat time related as it will happen if I just idle the car in the driveway.

I would like to clean the multi-pin connector on the back of the assembly but the Haynes manual I bought for the car does not show any procedure for removing or getting at the connector and it looks like a bigger procedure than just reaching in and pulling it out (not enough room to reach in between other body parts).

I tried that and looks like some pieces need to be removed for access, is that correct?

Any advice/tips are appreciated.

WD