Crankshaft Gear center bolt torque specs

[Vallyv]

This came in handy, as my Timing belt jumped and luckily from what we can see no rockers/valve broken or bent. However my Crankshaft Gear center bolt got jammed and we had to grind it off, got new Bolt, Spacer and Gear but need the Torque Tightening Nm/Ft Lb spec for Bolt is not showing on/in WIS (or am i looking in wrong place)..any help you can provide would be great thanks again.

08 9-3 Vector Sport 1.9 TTid 180bhp.

Apologies if in wrong thread as searched everywhere but all i can find is 9-5 spec for 2.2 and 3ltr.

[GeoffR]

If you look at any bolt in WIS there should be a link to standard torque values, I haven't got a copy of WIS available at the moment so I can't confirm that. You may need to look at a different model to find what you need.

[Vallyv]

Thanks for this GeoffR, i have a copy of WIS (from op) but link doesn't show torque setting for this, all it says is " " as in my first post all i can find is torque setting for the 9-5.

[GeoffR]

Thanks for this GeoffR, i have a copy of WIS (from op) but link doesn't show torque setting for this, all it says is " " as in my first post all i can find is torque setting for the 9-5.

If the setting for the 9-5 is for the same engine, use that.

If the setting for the 9-5 is for a different engine you may be able to find the setting by contacting a specialist of the engine manufacturers products. I am not sure who makes the 1.9 engine, I think it is Fiat, so contact your local Fiat dealer and see if they can help.

[Vallyv]

If the setting for the 9-5 is for the same engine, use that.

If the setting for the 9-5 is for a different engine you may be able to find the setting by contacting a specialist of the engine manufacturers products. I am not sure who makes the 1.9 engine, I think it is Fiat, so contact your local Fiat dealer and see if they can help.

Cheers, will give that a try..that said, we torqued it to 160Nm which is in keeping with the 4cyclinder diesel.