Hi all, so recently the saab has thrown another curve ball at me and it again seems electrical in nature. "P0341: Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1 or Single Sensor)" I changes BOTH sensors, started the car up and check engine and error was still present. Which now mean I must have an issue in the wire running from the sensor to ECU (ME9) in the back of the engine.

Guy suggested I just run new wires to the connector. My question is this, is this a common solution and how do you actually use and/or get the correct exact connectors so you can place it into the plastic connectors? I have the depinning tool just don't know how to get a hold of the stock pin connectors.

Thoughts