Results 1 to 1 of 1
-
10 September 2019 #1
- Join Date
- 02 Mar 2015
- Location
- united states
- Posts
- 13
- Saab(s)
- 2000 convertible 9-3; 2007 93 Aero v6
P0341 - How to fix and/or Repin a Wire? Delphi connectors etc
Hi all, so recently the saab has thrown another curve ball at me and it again seems electrical in nature. "P0341: Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1 or Single Sensor)" I changes BOTH sensors, started the car up and check engine and error was still present. Which now mean I must have an issue in the wire running from the sensor to ECU (ME9) in the back of the engine.
Guy suggested I just run new wires to the connector. My question is this, is this a common solution and how do you actually use and/or get the correct exact connectors so you can place it into the plastic connectors? I have the depinning tool just don't know how to get a hold of the stock pin connectors.
Thoughts
Similar Threads
-
Mystery wire/hose
By m3245 in forum Saab 9-3 (2003-2014)Replies: 0Last Post: 04 August 2019, 22:25 -
Retrofit original delphi grundig satnav
By beomoth in forum Saab 9-3 (2003-2014)Replies: 1Last Post: 02 September 2015, 08:19 -
Tax disc holder - what is the wire for?
By bandsawman in forum Saab 9-5 (1998-2009)Replies: 7Last Post: 05 March 2015, 20:54 -
Disconnected sensor and a loose wire. IS this right??
By Nathan 9⁵ in forum Saab 9-3 (2003-2014)Replies: 3Last Post: 30 July 2012, 00:56 -
Can someone tell me what the wire is for?
By jchang in forum Saab 9-5 (1998-2009)Replies: 2Last Post: 03 April 2011, 19:48