Welcome to the world of Saab ! Register
Results 1 to 2 of 2
  1. #1
    Saab Enthusiast
    Join Date
    13 Jun 2019
    Location
    Colorado
    Posts
    108
    Saab(s)
    1999 9-5 wagon
    Thumbs Up:   3

    ACC blend door issues

    The abnormally cold weather made me realize that my 99 9-5 wagon 2.3t was blowing cold on the drivers side and hot on the passenger side. Checked on WIS and found the issue was a broken "arm" as well as the shaft that the arm was connected to. Ordered the 1 piece aluminum option and was able to get it on (had to cut out the opening a little to allow the aluminum sleeve to fit through the hole). But the question I have is in regards to the plastic bushing that came with the new part. Its supposed to connect to a rod that operates a flap in the floor that I am assuming affects the vents going to the rear seat. There was no rod in there. Over the summer, I had pulled the carpet out for a complete detailing job and never noticed any rod laying around in that area. Is it possible that my ride doesnt have one of those rods? I really dont want to pull the seat out and remove that front carpet again. At least not until it gets into spring.

    I also checked for fault codes after fixing it (and it does work correctly) and I get code 8 and 11 meaning the blend doors on both sides are not working correctly. I will dig into the RH side later to confirm and check on that rod/arm/motor later but for the moment, it seems fine.

    0 Not allowed!
    Last edited by BeardedFool; 15 February 2021 at 01:28. Reason: Spelling

  2. #2

    Join Date
    18 Aug 2015
    Location
    United States
    Posts
    4
    Saab(s)
    1997 900 SE Talladega, 2000 9-5 Aero wagon
    Thumbs Up:   0
    I'm guessing that you replaced the blend door arm on the driver's side. The rod for the back seat vents is only on the passenger's side. I have two 9-5s, and the rod has popped out of the arm on both of them over the years, but it should still be visible sticking up if you're looking on the passenger's side and have the glove compartment out.

    0 Not allowed!

 

 

Similar Threads

  1. ACC Heater Box Destruction and Bled Door Arm removal tool?
    By Kazamario in forum Saab 9-5 (1998-2009)
    Replies: 4
    Last Post: 27 November 2017, 12:27
  2. Door locks
    By chuck35lopez in forum Saab 9-3 (2003-2014)
    Replies: 11
    Last Post: 17 November 2017, 22:07
  3. Replies: 5
    Last Post: 28 June 2016, 22:37
  4. No sound from all 4 door speakers - 2002 9-5 5 door AS3
    By xam247 in forum Tutorials, repairs and service
    Replies: 0
    Last Post: 07 April 2016, 15:27
  5. Door key won't lock drivers door ? Etc/... newby
    By Samual9-5 in forum Saab 9-5 (1998-2009)
    Replies: 1
    Last Post: 24 August 2015, 03:11

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
All times are GMT. The time now is 07:32.
Powered by vBulletin® Version 4.2.5
Copyright © 2021 vBulletin Solutions Inc. All rights reserved.