Welcome to the world of Saab ! Register
Page 11 of 12 FirstFirst ... 9101112 LastLast
Results 101 to 110 of 113
  1. #101
    Saab Fan
    Join Date
    08 Jan 2019
    Location
    UK
    Posts
    28
    Saab(s)
    9.5
    ah missed it. thanks.

  2. #102
    Saab Fan
    Join Date
    08 Jan 2019
    Location
    UK
    Posts
    28
    Saab(s)
    9.5
    Thanks folks, worked a dream.

    One more question. I overfilled just a tat above the top line of the stick. is that a problem? And how would one remove it if needed?

  3. #103
    Frank
    Administrator nordwulf's Avatar
    Join Date
    30 Jul 2010
    Location
    USA - Netherlands
    Posts
    7,901
    Saab(s)
    previous: 2006 9-3, 2001-06 9-5, 2011 9-4X
    You can loosen the drain plug just a bit and let some fluid drain out. But if it is just a tat, it probably doesn't matter.

  4. #104
    Bruno
    Saab Addict swisssaabist's Avatar
    Join Date
    18 Nov 2016
    Location
    Cheeseland or TICTAC land
    Posts
    603
    Saab(s)
    9-5 ARC Wagon 2002 2 t auto engine B205E
    Don't let the gearbox overfilled it could induce lots of issues

  5. #105
    Saab Fan
    Join Date
    08 Jan 2019
    Location
    UK
    Posts
    28
    Saab(s)
    9.5
    Quote Originally Posted by swisssaabist View Post
    Don't let the gearbox overfilled it could induce lots of issues
    My fear, like what?

    Could I suck it out over the dipstick hole? Any experience doing that?

  6. #106
    Saab Fan
    Join Date
    08 Jan 2019
    Location
    UK
    Posts
    28
    Saab(s)
    9.5
    Quote Originally Posted by morganj2003 View Post
    Thanks for the terrific writeup! I've followed your directions completely so far. Although, I'm having a difficult time tracking down a replacement washer for the ATF pan. Where did you obtain yours?

    Thanks!
    Tip for anybody having a hard time finding them washers, Volvo seems to have them too. failing that take a 800 grade sandpaper and sand a wee bit of till flat again.

  7. #107
    Saab Fan
    Join Date
    08 Jan 2019
    Location
    UK
    Posts
    28
    Saab(s)
    9.5
    Quote Originally Posted by ChangeAgent View Post
    Tip for anybody having a hard time finding them washers, Volvo seems to have them too. failing that take a 800 grade sandpaper and sand a wee bit of till flat again.
    In case anybody wants to repeat this.

    I managed to get it out over the dipstick hole. Took a 5MM piece of transparent tubing (I did not want to take a larger diameter as I was worried I would not get in past the bends). Transparent so I can see what happens. Made the end I wanted to insert tapered. Put a piece of tape on the tubing to indicated the same length of the dipstick (so I know how deep I am in). Took a strong plastic transparent bottle (any soda bottle would do). Drilled a 4.5MM hole near the top, where the plastic is thick. Put the other hose end in and sealed it with some putty (probably overkill, but there you go). Used one of those devices that they sell for closing your wine bottles after you took a small amount out, with a rubber cork and a plastic vacuum device. The cork just fits in the Soda bottle and you might need to use some downward pressure as you pump to get a good vacuum.

    After a run with the oil warm (it is less thick) I stuck the tubing in (engine not running as you do not want the gears to eat your tubing), I stuck the tubing in. There is a moment of resistance at the point where you tape is about 2 inches from the edge. A bit of fiddling up and down will get you past it. I went about an inch past the tape to be sure I am in the oil.

    Now start pulling vacuum on the bottle and slowly oil will come up and dribble into the bottle. The bottle will collapse a bit but mine did a good job in bringing up the excess oil. Keep the vacuum constant and it works, not fast but it works.

    I disposed of the oil (not sure if the process contaminated it) in the usual responsible way at the recycling place in the next town.

    Be well be happy.

  8. #108
    Saab Fan
    Join Date
    08 Jan 2019
    Location
    UK
    Posts
    28
    Saab(s)
    9.5
    Question as to the oil level.


    I can not get a consistent reading of the level. I followed different instruction I found on forums for Saab.


    Here are two methods discussed:


    http://www.uksaabs.co.uk/UKS/viewtopic. ... 3#p1825313


    And neither one gives me a reading that is consistent. Now I admit I can not measure if the engine is exactly at the right temperature, but I figured a longer ride will do this.


    Any tips? Anybody else with the same experience?


    Thanks.

  9. #109
    Saab Fan
    Join Date
    08 Jan 2019
    Location
    UK
    Posts
    28
    Saab(s)
    9.5

  10. #110
    Saab Fan
    Join Date
    24 Oct 2019
    Location
    Collierville TN
    Posts
    48
    Saab(s)
    2007 Saab 9-5 Aero Sportcombi
    When changing the fluid is a tech 2 tool needed? 2006 9-5 aero wagon.

 

 

Similar Threads

  1. Automatic transmission lock-up solenoid
    By SaabWorld in forum Tutorials, repairs and service
    Replies: 1
    Last Post: 20 February 2017, 15:46
  2. Saab 9-5 gear selector casing (automatic) - WIS
    By SaabWorld in forum Tutorials, repairs and service
    Replies: 6
    Last Post: 01 August 2016, 14:31
  3. Manual gearbox fluid change - Saab 9-5
    By SaabWorld in forum Tutorials, repairs and service
    Replies: 0
    Last Post: 14 October 2010, 04:03

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
All times are GMT. The time now is 06:48.
Powered by vBulletin® Version 4.2.5
Copyright © 2024 vBulletin Solutions Inc. All rights reserved.