Results 1 to 1 of 1
-
26 December 2013 #1
Jeffrey Master SaabTech/Moderator
- Join Date
- 25 Oct 2010
- Location
- Point Pleasant, PA
- Posts
- 1,317
- Saab(s)
- - 86' 9KT - 95' 9K Custom CS - 06' 9-3 Combi - 07' 9-7X Arc - 08' 9-3 Convertible - 08' 9-3 TurboX -
2003 - 2011 9-3 TCM Fault Code P1743-64 or P1743 Diagnostic Information via WIS
[FONT=Verdana]P1743 64
[/FONT]
[FONT=Verdana]Lock-up. Mechanical Fault.[/FONT]
[FONT=Verdana]Fault symptom[/FONT]
[FONT=Verdana]Message appears in display.[/FONT]
[FONT=Verdana]On-board diagnosis[/FONT]
[FONT=Verdana]Type of diagnosis:[/FONT]
Continuous
[FONT=Verdana]Enable criteria:[/FONT]
Engine running and not in limp home mode. The following diagnostic trouble codes may not be generated: Gearbox Input RPM Output speed. Gear selector position sensor Gearbox Fluid Temperature Sensor Battery Voltage. Too High. Solenoid SLT Engine RPM Wheel speed fault Pedal Position Sensor Engine Torque Solenoid S1 Solenoid S2 Solenoid S3 Solenoid S4 Solenoid S5
[FONT=Verdana]Fault criteria:[/FONT]
TCM registers rapid speed changes on the output shaft or TCM registers a difference greater than 100 rpm between input shaft speed and engine rpm.
[FONT=Verdana]System reaction to a fault:[/FONT]
Excluded Lock-Up function. Poor shifting quality.
Procedure to DIAG:
Check:
- Oil level
- Oil grade
Check that the sensors for input shaft speed and output shaft speed are correctly mounted on the gearbox
Remove component:
Speed sensor, input shaft, gearbox
Speed sensor, output shaft, gearbox
Check that the sensors for incoming rpm and outgoing rpm are free from dirt and are undamaged.
IF all check out OK then you will be needing a Transmission.European Motor Services, LLC - Point Pleasant, PA 18950 - www.europeanmotorsvc.com