Wiring in HID fog lights

[IAmTodd]

I ordered an HID kit from DDM Tuning a while ago. Install went well and I used the stock fog light wiring harness. I had igniting issues and being familiar with HID installs I made my own relay harness.

I'm thinking at this point I need a resistor on the kick on lead for the relay (I used the hot lead from the drivers side fog for that) to stop the constant relay tick. I believe it is also need because the relay constantly, and quickly pulsates when the fogs are on when the car is running. I just don't know what size resistor?

I am ordering a set of HIDs for my dad soon and I might invest in a set of the error cancelers from DDM to see if that solves the issue when using the stock harness only.

[jlrSAAB]

for fog lamps you must use H3 bulbs to avoid problems in the BCM as the power is monitoring by the computer system.
- you cannot change the resistances values of the bulbs.

[IAmTodd]

No, I will be using the HID bulbs. A resistor needs to be put on the stock wiring to fool it into thinking there is a a bulb attached to it.

I will be using error eliminators to see if they cure this issue.

[jlrSAAB]

did you read the Notice in the above picture in post no. two?
sorry I can't help you. may somebody else can give you a thought to solve you problem.
my recommendation is going back to the genuine bulbs and wires diagram according the specifications of your car to avoid issues.